I would bring it to an old time radiator shop and
have them solder up the cracks and pressure test. It will likely cost under $100
and the work should be guaranteed.
Ron
----- Original Message -----
Sent: Tuesday, June 23, 2015 10:01
AM
Subject: [FWDLK] Radiator
Yesterday I was herding kittens!! I have the radiator out.
There were a couple of leaks in the tubes that I soldered. There are a
few extremely small leaks where the tubes enter the top tank. I am
unsure how to get heat, flux and solder in to the leaks. Any
ideas?
Kenneth G. Rimington
Orbital ATK Launch
Systems
Electrical Design
Engineer
PO Box 707, Mail Stop: UT40-B/1/H-21
Test Instrumentation and
Integration Brigham City, UT 84302-0707
Notice: This
e-mail is intended solely for use of the individual or entity to which it is
addressed and may contain information that is proprietary, privileged and
exempt from disclosure under applicable law. If the reader is not the intended
recipient or agent responsible for delivering the message to the intended
recipient, you are hereby notified that any dissemination, distribution or
copying of this communication is strictly prohibited. This communication may
also contain data subject to U.S. export laws. If so, that data subject to the
International Traffic in Arms Regulation cannot be disseminated, distributed
or copied to foreign nationals, residing in the U.S. or abroad, absent the
express prior approval of the U.S. Department of State. If you have received
this communication in error, please notify the sender by reply e-mail and
destroy the e-mail message and any physical copies made of the communication.
Thank you.
********** **********
*************************************************************
To unsubscribe or set your subscription options,
please go to http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1
Help The Forward Look with every Amazon purchase by clicking
here! Help the
Forward Look with every eBay purchase by starting your search
here!
*************************************************************
To unsubscribe or set your subscription options,
please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1
Help The Forward Look with every Amazon purchase by clicking here!
Help the Forward Look with every eBay purchase by starting your search here!
|