|
Yesterday I was herding kittens!! I have the radiator out. There were a couple of leaks in the tubes that I soldered. There are a few extremely small leaks where the tubes enter the top tank. I am unsure how to get heat, flux and solder in to the leaks.
Any ideas?
 Kenneth G. Rimington Orbital ATK Launch Systems
Electrical Design Engineer PO Box 707, Mail Stop: UT40-B/1/H-21
Test Instrumentation and Integration Brigham City, UT 84302-0707
Notice: This e-mail is intended solely for use of the individual or entity to which it is addressed and may contain information that is proprietary, privileged and exempt from disclosure under applicable law. If the reader is not the intended recipient or agent responsible for delivering the message to the intended recipient, you are hereby notified that any dissemination, distribution or copying of this communication is strictly prohibited. This communication may also contain data subject to U.S. export laws. If so, that data subject to the International Traffic in Arms Regulation cannot be disseminated, distributed or copied to foreign nationals, residing in the U.S. or abroad, absent the express prior approval of the U.S. Department of State. If you have received this communication in error, please notify the sender by reply e-mail and destroy the e-mail message and any physical copies made of the communication. Thank you. ********** ********** ************************************************************* To unsubscribe or set your subscription options,
please go to Help The Forward Look with every Amazon purchase by clicking here!
|
Back to the Home of the Forward Look Network