The issues in the previous thread were worked out. I was not getting any pedal at the time. Now I can pump it up. Also, I'm asking about peoples' experiences with stainless lines. Ron ----- Original Message ----- From: "John McCann" <jmccann@xxxxxxxxxxxxxx> To: "Ron Waters" <ronbo97@xxxxxxxxxxx>; <L-FORWARDLOOK@xxxxxxxxxxxxx> Sent: Sunday, October 16, 2005 4:56 PM Subject: Re: [FWDLK] Stainless Steel Brake Lines > This was discussed recently, follow this thread to follow the last > discussion http://www.forwardlook.net/mail-archive/msg28341.html Good luck > John > > ----- Original Message ----- > From: "Ron Waters" <ronbo97@xxxxxxxxxxx> > To: <L-FORWARDLOOK@xxxxxxxxxxxxx> > Sent: Sunday, October 16, 2005 10:20 AM > Subject: [FWDLK] Stainless Steel Brake Lines > > > > Hi Gang - > > > > I purchased pre-formed stainless steel brake lines for my 58 Ply several > > years ago. So now they're installed, but I seem to have a small amount of > > leakage from the back of the nut, even though I've tightened the nuts as > > much as possible. Has anyone else encountered this problem ? Additionally, > > I > > wrapped the threads in teflon tape in case that was the problem. > > > > I'm also having problems with getting a solid pedal. First time I step on > > the pedal, it goes most of the way to the floor. Second time immediately > > afterwards, pedal is somewhat hard. Third time, it is hard. If I don't > > step > > on the pedal for a few seconds, we repeat the scenario. Brakes have been > > bled many times already, with smooth stream coming out each time. > > > > Any thoughts ? Should I replace the stainless lines with regular steel > > lines > > ? Drums have been pulled and wheel cyl's examined, looking for leakage > > inside. There is none. > > > > Any thoughts ? > > > > Ron > > > > ************************************************************* > > > > To unsubscribe or set your subscription options, please go to > > http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1 > > > > > ************************************************************* To unsubscribe or set your subscription options, please go to http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1
|