Re: [FWDLK] gas gauge questions

[Jan & Roger van Hoy <vanhilla@xxxxxxxxxxxx>]

Ok, here's what I've heard so far---

 

my expectation is poor contact in the tank unit.  on and off contact would make it jump a lot.  Just a little fuel movement would move it just enough to flutter.let car sit for an hour and then turn switch on without getting in or jiggling the car.  Bet is doesn't move them but still could if at right point.

You lose.  The needle jumps back and forth without even getting into the car.

 

Rock and roll of the fuel against the float.

 

See above

 

varnish build up on the resistance wire in he sending unit in the tank.  Try adding some carb cleaner to the gas or remove the sending unit and soak/rinse in acetone or lacquer thinner.

 

Maybe we're on to something here.  But standing still?

 

Faulty fuel gauge..time to remove and repair, or find a replacement.

 

Ahh, that leads me to my second question.  I just happen to have a 6v '55 Plymouth fuel gauge which will fit right in.  But will it work?  Is the '56 12v system reduced to 6v by the voltage limiter?

 

So any more suggestions would be welcome...

 

--Roger

 

----- Original Message -----

From: "Jan & Roger van Hoy" <vanhilla@xxxxxxxxxxxx>

To: <L-FORWARDLOOK@xxxxxxxxxxxxx>

Sent: Friday, August 18, 2006 8:23 AM

Subject: [FWDLK] gas gauge questions

> These are probably some of 
the dummest questions I've asked...
> 
> [1] What causes a gas gauge 
needle to bounce/jerk/flutter rapidly back and 
> forth?  This 
happens in my '56 Plymouth whether or not the car is moving and 
> at any 
amount of fuel except plumb full.  Seems to be too fast to be the 
> 
float unit. [This is a hardtop; electromagnetic gauge not the SW 
> 
thermostatic gauge.]
> 
> [2] What's the difference between a 6v 
fuel gauge and a 12v fuel gauge, 
> specifically in the '55-'56 
Plymouths?  Doesn't the voltage limiter on the 
> 12v drop the 
voltage down to 5-6v?
> 
> --Roger van Hoy, Washougal, WA, '55 
DeSoto, '58 DeSoto, '56 Plymouth, '66 
> Plymouth, '41 Dodge 
> 
> *************************************************************
> 
> To unsubscribe or set your subscription options, please go to
> 
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1
>

*************************************************************

To unsubscribe or set your subscription options, please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1