RE: IML: Digital radio/81 Imperial Help
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: IML: Digital radio/81 Imperial Help



As Bob Baker has already pointed out, you cannot make this change unless you also change the power amp (the one that is mounted where the center dash speaker would be mounted in a lesser car. The correct power amp is clearly marked as being for a “Quartz Lock” radio only.  Once done, this produces a superb sounding radio, with all the modern convenience of digital tuning etc.  The 82/83 radios have this feature from the factory, the 81s do not.  

 

The heating and smoke are telling you that you are about to totally destroy your radio – turn it off and leave it off until you get the right power amp!

 

Dick Benjamin

 


From: mailing-list-owner@xxxxxxxxxxxxxxxx [mailto:mailing-list-owner@xxxxxxxxxxxxxxxx] On Behalf Of RWestra@xxxxxxx
Sent: Wednesday, December 29, 2004 2:34 PM
To: mailing-list@xxxxxxxxxxxxxxxx
Subject: IML: Digital radio/81 Imperial Help

 

I am trying to replace an original equipment analog dial radio in my 81 Imperial with a digital dial Chrysler radio of perhaps a little later vintage.

The radio I am trying to install is an AM/FM/Cassette with the six small pushbuttons to the left of the readout.  It has the gray and black. 7 wire, 4 speaker system connectors on the back.  I have carefully connected the wires as correctly as I can.  The four positive  speaker wires were connected to the appropriate speaker plug going to the rear amp.  The negative speaker wires were joined together and connected to the black wire on the rear amp plug. 

 

Now the problem.  When I connected the radio to the '81 I got a pulsing intermittent radio sound from the speakers.  I cut the black wire to the plug and the radio worked.  However,  it runs very hot.  After about 15 minutes of operation I saw smoke coming from the power transistor area.   You can see the digital readout dim slightly when heavy base tones are played.  The radio sounds great but I suspect life will be short.  Maybe an hour or so.

 

My suspicion is that with the black ground wire disconnected the power transistors are running out of control and overheating.  By connecting a 10 ohm power resistor in the break in the black ground wire the base tones are subdued but the radio still runs hot.     By now you electronic types will recognize that I have no idea what I am talking about.  But I do need help.

 

Has anyone made the conversion from the analog dial radio to a two plug, four speaker, digital dial, successfully.  If so what do you suggest.  I am tired of pulling the analog dial radio every six month for the bi-annual volume control bath.  Also the tape player has started to eject while playing. 

 

Thanks for your help.

 

                                                                    Rolland Westra



Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.