The drums cover the guts of the brakes, and removal of them is the only path to access them. I would suggest that you expect some front end bushing or small component work to be required. If something's worn out and lets the car ride straight until the brakes are applied, you could have more than uneven brake efficiency. I highly, highly suggest that you do all parts of the system at one time. Get wheel cylinders for all four wheels as well as a master cylinder. All of these parts are probably the same age. Replacing one and then not the others, waiting for them to exhibit symptoms? BAD idea. If one goes, it's my contention that the others are probably not too far behind. Once done, you can drive the car with confidence that you will not have a huge scare while in motion with a pedal on the floor. If the labor isn't your thing, try going to Midas or a brake place, but check on parts availablility and cost before committing. They should be able to get these things for you first so that you don't have the car sitting on a lift while they wait for the parts. -Kenyon > ----- Original Message ----- > From: Rex Crews > To: mailing-list@xxxxxxxxxxxxxxxx > Sent: Sunday, September 08, 2002 4:53 PM > Subject: IML: 1959 Brakes > > > Hi Fellow Imperialists, > > I have a question about removing and servicing the > front brakes on my '59 Crown. To replace the front > cylinders recently I practically had to remove and > dismantle the entire wheel to get the cylinders out. I > am sure there must have been an easier way. I know I > need a shop manual, but I am wondering what the "quick" > method for removing the cylinders would be? Then, how > does one properly adjust those front brakes? I do have > brakes now, but they pull badly to the left. > > Thanks in advance for the friendly advice! > > Rex Crews > __________________________________________________ Do You Yahoo!? Yahoo! Finance - Get real-time stock quotes http://finance.yahoo.com