They only adjust from one side. You can shim both axles tho. Shim until you are fairly close then use the adjuster to tighten until you have the right amount of play. You can just barely move the axle back and forth, where you can just feel a little play. Very little play. I usually tighten them fairly tight then thump the axle fairly hard with a maul or big hammer. This helps set the axle. Then finish adjusting.. ----------------- http://www.imperialclub.com ----------------- This message was sent to you by the Imperial Mailing List. Please reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be shared with everyone. Private messages (and attachments) for the Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm