Re: IML: crankshaft pulley repair
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: IML: crankshaft pulley repair



Why is it such a problem then if the outter ring has slipped?
I mean, you only have to find TDC of the #1 cyl and make a new mark on the
ring???

Or do I miss something here?

Thanks,

Robert




Op Vr, 13 oktober, 2006 7:52 pm, schreef DR CHALLENGER:
> if thats true the damper is junk, needs to rebuilt or replaced.
>
>
>> From: "Dave" <Wilkerbeast01@xxxxxxxxxxx>
>>
>>>
>> It can if the outter ring has slipped on the inner ring.
>>
>>
>> David C. Wilker Jr. USAF (RET)
>>
>>
>> --- My memory's not as sharp as it used to be.
>> Also, my memory's not as sharp as it used to be.
>>
>>
>> ----- Original Message ----- From: "DR CHALLENGER"
>> <drchallenger@xxxxxxxxxxx>
>> To: <mailing-list@xxxxxxxxxxxxxxxx>
>> Sent: Thursday, October 12, 2006 2:17 PM
>> Subject: Re: IML: crankshaft pulley repair
>>
>>
>>
>>> The damper only goes on 1 way, it cant be 180 degrees off.
>>>
>>>
>>>
>>>> From: David Whitney <hazegreen66@xxxxxxxxx>
>>>> )
>>>>
>>>>
>>>>
>>>>
>>>>
>>>>
>>>> When you change the balancer, you MUST be certain that the TDC mark
>>>>  (the one you use to set timing) is actually pointing to 0 on the
>>>> plate affixed to the timing chain cover when cylinder 1 is at EXACT
>>>> top dead center on the COMPRESSION cycle.  The most common mistake
>>>> is getting it 180 degrees out.  Having it off by a few degrees will
>>>> merely make it difficult to set the timing because you won't want to
>>>> believe your eyes when you see how many degrees initial advance you
>>>> have.
>>>>
>>>> Some of what I have written is merely interesting.  The important
>>>> sentences have words in CAPS.  Not abbreviations... words.
>>>>
>
>
>
>
> -----------------  http://www.imperialclub.com  -----------------
> This message was sent to you by the Imperial Mailing List. Please
> reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be shared
> with everyone. Private messages (and attachments) for the Administrators
> should be sent to webmaster@xxxxxxxxxxxxxxxx To UN-SUBSCRIBE, go to
> http://imperialclub.com/unsubscribe.htm
>
>
>




-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please 
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm



Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.