Re: IML: trans temp sensor
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: IML: trans temp sensor



Brad,

Ideally you would want the temp sensor in the line going TO the radiator where the fluid is the hottest, but that would take a bit of plumbing as you would need to fabricate some sort of T or what have you that is large enough to accomodate the temp sensor fitting .

Most of the time they are installed in the pan, but one must make triple sure of whats on the other side of the pan before you make the hole for it, because of clearance. The other wrinkle is that you would need the bung fitting installed into the pan to thread the sensor into.

Check B&M, or in even some of the aftermarket gauge makers and see if they offer a kit for the install.

Mikey




----------------- http://www.imperialclub.com -----------------
This message was sent to you by the Imperial Mailing List. Please reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm




Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.