Re: IML: plates on the trans mount

["mike sutton" <mikanlin62@xxxxxxxxxx>]

Any chance those little plates on the trans mount were used as shims to 
change a driveshaft angle?  The FSM shows shims on the center bearing 
support but I dont recall seeing any on my 62 or on the two 63's  that I 
have owned.  There is quite a bit of text in the service manual regarding 
the indexing and the anglularity of the prop shaft,  maybe someone in the 
past had tried to correct a problem.

Mikey
62 Crown Coupe 




-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please 
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm