IML: LED Lamp Units
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

IML: LED Lamp Units



Christopher,
Thanks for the reply. I'll assume for the moment that you've replaced the front turn signal, tail, backup, and license plate bulbs with LED units? I've seen LED units w/a grouping of aprox 10 LEDs in use in a friend's taillight but they were deemed too dim. They were an inexpensive off the shelf item. Can you refer the brand and/or specs of the units you have in your '62? I picture them being pretty effective in a '62 tail lamp cone. Are there LED units that allow for a seperation of LEDs so that one lamp can act like a dual filament bulb for the brake lighting, or do the LEDs simply increase in light output? The instant on and off of LEDs has a safety quotient in alerting the already awestruck tailgater that the massive gunsight tail lamped vehicle ahead of them has just dropped anchor.
Thanks, again.


Eric
Portland, Oregon

**********************************************
Subject: RE: IML: Headlights
From: "Christopher Middlebrook" <delamothe@xxxxxxxxxx>
Date: Fri,  1 Oct 2004 08:54:36 -0400 (EDT)
Reply-To: mailing-list@xxxxxxxxxxxxxxxx

Eric
You bring up many excellent points, and I agree with you about the perils of increasing the load on our cars from these new lamps. Especially in the case of the generator driven Imperials.
But if it must be done, then a relay is definitely the way to do it properly. There are some very good solid state relays out there that can do the job without having to deal with contacts that require cleaning or replacing over time.


If anything, the ideal situation is to decrease the current load on the charging system for better performance and stability.

(fuel economy too - an alternator at full field will require from 10 to 40 HP from the motor to turn it depending on its rated output)

This is why I have changed the bulbs on my 62 from incandescent to LED based. Aside from having a shorter time constant when turning on (Incandescent lamps require a period in time where the filament has to get hot enough to glow - LED's light up instantly giving the drivers behind you as much as a half second more to react.) LED's reduce the current demand on a charging system by 30%.




----------------- http://www.imperialclub.com -----------------
This message was sent to you by the Imperial Mailing List. Please reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm




Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.