Re: IML: Help: 1968 Coupe Carburator Installation

[Mike Pittinaro <mechimike@xxxxxxxxx>]

> I am replacing the carburator on my 1968 crown coupe
> with a new Edelbrock Performer series carb.  I have
> the Carb, the throttle cable and linkage cable
> parts.
> Am I missing anything?  Spacers? Fuel lines?  any
> help would be great on this... thanks. 

Not hard...I recently replaced my Holley 4160 with the
Carter AFB..similar swap, I imagine.  The edelbrock
performer requires a fuel hose be spliced into your
existing fuel line.  Your current carburetor probably
uses a screw in fitting.  You will need about 2 or 3
feet of 3/8" fuel hose, and two screw clamps for the
ends, to connect the existing fuel line to the carb. 
Make sure you put a fuel filter in the line!

You also need the Mopar automatic transmission
kickdown linkage adaptor, from Edelbrock.  

Other than that, the carb will bolt onto the existing
studs, the throttle cable will attach right on...you
may need to plug some of the vacuum connections to the
carb with little rubber stoppers, if they won't be
powering anything.  You will have two ports on the
front of the carb for distributor vacuum
advance...plug one, use the other.  One is a timed
advance, the other is a full advance.  I find my 67
runs better off the timed advance, but its a bit of a
trial and error thing.

=====
--Mike Pittinaro

Beautiful Boxcar
American Grandeur and
Danish modern Style


		
__________________________________
Do you Yahoo!?
New and Improved Yahoo! Mail - Send 10MB messages!
http://promotions.yahoo.com/new_mail 


-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please 
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm