IML: Mounting 440 on engine stand

["David Whitney" <david.whitney@xxxxxxxxxxxx>]

Hi, folks --

I ventured one step further into knucklebusting by purchasing an engine
stand in anticipation of building the 440 for my engineless project car.
It's the kind with four adjustable plates with bolt holes running through
them.  Since I have no engine, I also have no bolts with which to mount the
block to the stand.  I'm starting with a bare block, so it doesn't come
with any.  Can someone please give me the specs or part number for those
bolts so I can pick up a set?  It's a '65 casting stock block.

Also, will I need to pick up a flex plate or can I run the bolts directly
to the block?  If so, can it be any old flex plate or does it have to be
the one I'll have on there permanently?

Thanks,

David
'91 K-Imperial driver
'66 Crown Coupe project
'66 Newport 383 dual exhaust .030 over Eddys/B&M/Cragars daughter's first
Mopar




-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please 
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm