Remco;
The headers may fit the engine but they may not fit the car, it is even
difficult finding a set that will fit in a later C body car. Further headers
don't last as long as cast iron because they are made from tube steel which
rusts and burns through quicker. If they are stated to fit a Chrysler 300
there is a chance that they might fit, if not I would stay away from them.
Besides I am not sure if they would help a propane powered engine that much.
Best Regards
Arran Foster
1954 Imperial Newport
Needing A Left Side Tailight bezel and other trim parts.
----- Original Message -----
From: "r.van.Lent" <remco.nancy@xxxxxxxxxx>
To: <mailing-list@xxxxxxxxxxxxxxxx>
Sent: Tuesday, August 31, 2004 2:20 PM
Subject: IML: headers in a 57
There are some headers for the 392 on ebay
will this fit in the 1957 body or is there a problem with the front
suspension
Remco The Netherlands
----------------- http://www.imperialclub.com -----------------
This message was sent to you by the Imperial Mailing List. Please
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm
----------------- http://www.imperialclub.com -----------------
This message was sent to you by the Imperial Mailing List. Please
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm
Back to the Home of the Forward Look Network