Master Cylinder Access 1958

[RandalPark@xxxxxxx]

If it is factory, you use a 3/8 or 7/16 wrench to remove the screw that holds 
the lid on the master cylinder. Lift the lid off, and fill if necessary. My 
trick is to use a small funnel with a length of hose attached to the end of it. 
Try not to spill brake fluid all over the place, though. It will eat the finish.

Most of this is done by feel since you really can't see what you are doing, 
except the level of the fluid may be visible if you have good light.

Enjoy!

Paul

In a message dated 6/26/2004 3:36:16 PM Eastern Daylight Time, 
daveford1@xxxxxxxxxxx writes:

> 
> 
> I went to check my Master Cylinder on my 58 wich has the Power Brake unit 
> over it.
> How does one access the master cylinder to remove the top and check/add 
> fluid??
> 
>    Thanks,
>     Dave
> 
> _________________________________________________________________
> MSN Movies - Trailers, showtimes, DVD's, and the latest news from Hollywood! 
> http://movies.msn.click-url.com/go/onm00200509ave/direct/01/
> 
> 
>