speed nuts

[roger crabtree <rcrabshish@xxxxxxxxxxxx>]

Beware! silicon and paint do not mix. 
RC Billings, Montanaaaaa

 --- Phil Patterson <hilljack7@xxxxxxxxxxxxx> wrote: >
I expect that its RTV silicon, or in older models,
> probably the old white potting sealant they used to
> use. I'd use RTV silicon, it should seal while not
> being too strong to prevent removal later.
> Phil <><
>   ----- Original Message ----- 
>   From: Bob 
>   To: mailing-list@xxxxxxxxxxxxxxxx 
>   Sent: Thursday, December 04, 2003 2:42 AM
>   Subject: IML: speed nuts
> 
> 
>   Does anyone know the correct sealant used in the
> hollow of speed nuts that hold on trim pieces?  I
> don't want to use anything with too much adhesive as
> the tangs on pot metal pieces are easy enough to
> break off as it is, but need to seal this source of
> water and moisture mitigation.  Years applicable are
> early 60's (1962), and there may have been more than
> one sealant used.  Thanks!!
> 
>   Bob
>  

http://personals.yahoo.com.au - Yahoo! Personals
New people, new possibilities. FREE for a limited time.