Square Bore Vs. Spread Bore
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Square Bore Vs. Spread Bore



The old Mickey Thompson made a spread bore plate that
did just that.  I went to the neiborhood speed shop
and they still have them.  They are now Cal Custom.  I
am not sure if the plate can be reversed but I think
it can.  It raises the carb height about 1.5 inches. 
This could be a problem in some instances. RC





 --- "A. Foster" <monkeypuzzle1@xxxxxxx> wrote: >
Hello All;
>   This seams like a stupid question but is there a
> way, in theory, to
> convert a square bore carberetor into a spread bore?
> I am just thinking on
> my feet here but could the air flow through the
> primaries of a square bore
> be restricted to achieve a similar effect to a
> spread bore? Would it make a
> difference?
> Thanks
> Best Regards
> Arran Foster
> 1954 Imperial Newport
> Nedding A Left Side Taillight bezel and other trim
> parts.
> 
> 
> 


Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.