Re: IML: Clock wiring

[PAUL WENTINK <randalpark@xxxxxxx>]

I believe that the clock should have a white wire with a red connector 
coming out of it for the electroluminescent lighting. I have a '62 and 
a '63, but I can't remember the wiring configuration for the clock. I 
believe that there is a metal tab that the power lead from inside the 
dash would connect to. The mounting screws serve as the ground.

I hope this helps.

Paul W.


-----Original Message-----
From: bcparent <bandcparent@xxxxxxx>
To: mailing-list@xxxxxxxxxxxxxxxx
Sent: Thu, 28 Feb 2008 8:45 am
Subject: IML: Clock wiring



Hi
I Just had the clock from my 62 cleaned and now it works when wound. The
problem is I think they mixed up a wire. When I took the clock out I 
believe
the black wire was attached to the incoming power source? Is this 
correct?
Now it is attached to the larger prong coming off the coil.
If this is incorrect, is the large tab coming off the side of the coil
supposed to be attached to the small wire coming out the side of the 
coil.
These two were not attached when I took the clock out and at the time I
believed that was the problem aside from needing the cleaning. Any help 
or
pictures would be appreciated.

62 Lebaron
Bernie Parent


----------------- http://www.imperialclub.com -----------------
This message was sent to you by the Imperial Mailing List. Please
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to iml.webmonster@xxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm



-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please 
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to iml.webmonster@xxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm