Re: IML: 1957 Imperial turning lens Option
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: IML: 1957 Imperial turning lens Option



Do you think they made their point?????
----- Original Message -----
From: gil
Sent: Wednesday, October 17, 2007 7:33 PM
Subject: RE: IML: 1957 Imperial turning lens Option

They were just trying to make a point,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,

 

-----Original Message-----
From: mailing-list-owner@xxxxxxxxxxxxxxxx [mailto:mailing-list-owner@xxxxxxxxxxxxxxxx] On Behalf Of Gary Wilson
Sent:
Wednesday, October 17, 2007 8:19 PM
To:
mailing-list@xxxxxxxxxxxxxxxx
Subject: Re: IML: 1957 Imperial turning lens Option

 

What is this.  I received on 50 email from the same person on the 57 turning lens.???

----- Original Message -----

Sent: Wednesday, October 17, 2007 11:06 AM

Subject: IML: 1957 Imperial turning lens Option

 

There is a '57 on Ebay with fender-top turning lights.  These are the lights that flash back at the driver to show the signal.  They are very common to later Chrysler products, but I don't think I've ever seen them on a car this old.  I wonder if they're after-market? Check it out at:

140168136637

 

Patrick

'58 Southampton (without fender turning lights)

 

----- Original Message -----

From: Gary Wilson

Sent: Wednesday, October 17, 2007 10:55 AM

Subject: Re: IML: 1956 Imperial WHEEL CYLINDERS

 

You got it right. I would put some sil glide on the rubbers and in the cyclinders.  Make installation much easy and just works better.  Or at least some brake fluid in the cyclinder and on the rubber cups. 

----- Original Message -----

Sent: Tuesday, October 16, 2007 10:06 PM

Subject: IML: 1956 Imperial WHEEL CYLINDERS

 

Im sorry everyone but I was tired and stupid last night when I asked the question about cylinders. What I was talking about were the Wheel Cylinder kits. The kits come pakaged so you can rebuild the front or the rears. The original wheel cylinders have an aluminum PISTON with the rubber boot made on the piston and then one spring. My question is what goes back in the cylinder from the generic rebuild kit? I would assume we have to use the original PISTON. The only thing I can see how to make them work is as follows.

 

Slide the spring in the cylinder.

Slide the rubber cup in the cylinder.

Slide the original PISTON with the Original rubber boot made on the piston in the cylinder.

Then of course the boot and link.

 

Please correct me if this is wrong. The cylinders have been honed and ready.

 

Thanks for any help.

Tim Hulse

Bakersfield Ca

1956 Imperial



Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.