Re: IML: Seat belts-1960

[richard burgess <lecrown60@xxxxxxxxx>]

Dear Donn,

 

I have a '60 LeBaron with factory belts and using those patterns I am about to drill the holes in my '60 Crown.  The outside belts were bolted to body mount bolts and I have measurements for the inner.  Of course the Lebaron had only two pair on the front seat so the back is a guess.  They say Chrysler and I am sure they are original to the car.  I'll try to get you the info./pictures out this weekend.

 

Richard Burgess

'60 Crown

Donn Reese <DReese@xxxxxxxx> wrote:

> My car didn't come with seat belts. I bought a set from Bob H.....but how do you install them?
>
> I haven't found a picture or installation discussion in any of the publications. They obviously need to bolt through the floorpan, and it seems the nut should go on the
>  bottom side. Assuming there is a nut as I only received the bolts. My big problem is locating where to bolt them down. Could someone with a similar year Imperial share a couple pictures of where their seat belts are bolted down? Under the back seat would be great too. Email me off list.
>
> Does anyone know if there is a knock-out in the floor pan for the bolts or do I need to drill holes?
>
> Thanks,
>
> Donn Reese
> 1960 Custom 4dr HDTP
>
>
> ----------------- http://www.imperialclub.com -----------------
> This message was sent to you by the Imperial Mailing List. Please
> reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
> shared with everyone. Private messages (and attachments) for the
> Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
> To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm

---

Yahoo! Messenger with Voice. Make PC-to-Phone Calls to the US (and 30+ countries) for 2¢/min or less.