Re: IML: Seat belts-1960
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: IML: Seat belts-1960



Donn,
     I know that in my 69 LeBaron 4DRHT, there were dimples in
the floorpan indicating where holes were to be drilled.  I found
the locations for the rear heater water lines this way and also
by looking at the FSM VERY CLOSELY.  As far as I know the rear
heater / Airconditioner is only briefly mention in the 69 FSM.
     As for the anchors for the seat belts, make a 3" square of
1/8+" metal with a centre hole in it for the bolt to go through. 
You want to distribute the strain on the floorpan over a wider
area and NOT just the hole through the floorpan.  ALSO, use stout
large washers to assist in doing that.  As for drilling through
the floorpan, a good trick to do is to drill a VERY small hole in
the floorpan to locate the center of the LARGE hole and have
CLEARANCE from other objects beneath.  In using the VERY SMALL
hole you can easily fill it if it is not in a good location.

Æyn

--- Donn Reese <DReese@xxxxxxxx> wrote:

> My car didn't come with seat belts.  I bought a set from Bob
> H.....but how do you install them?
> 
> I haven't found a picture or installation discussion in any of
> the publications.  They obviously need to bolt through the
> floorpan, and it seems the nut should go on the bottom side. 
> Assuming there is a nut as I only received the bolts.  My big
> problem is locating where to bolt them down.  Could someone
> with a similar year Imperial share a couple pictures of where
> their seat belts are bolted down?  Under the back seat would be
> great too.  Email me off list.
> 
> Does anyone know if there is a knock-out in the floor pan for
> the bolts or do I need to drill holes?
> 
> Thanks,
> 
> Donn Reese
> 1960 Custom 4dr HDTP
> 
> 
> -----------------  http://www.imperialclub.com 
> -----------------
> This message was sent to you by the Imperial Mailing List.
> Please
> reply to mailing-list@xxxxxxxxxxxxxxxx and your response will
> be
> shared with everyone. Private messages (and attachments) for
> the
> Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
> To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm
> 
> 



-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please 
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm



Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.