Ok, my car has been non-driving for 2 years, I have run the engine. I have had to pull it with the truck to move it around the shop. I rebuild all the brakes but the car still doesn't want to budge. I traced the resistance to the rear drivers side, so i pulled the drum backed the brakes off a bit and sanded all rust from both surfaces. The drum went on easy, I had high hopes. NOW, the wheel turns easy for awhile then gets very hard. No rime on reason here; might turns easy for 1, 3, 4, or 7 turns then go hard. THEN, when I reverse direction it may be easy or hard. AND when it is hard it may stay hard or go easy again. Thanks for the ideas, Charles _______________________________________________ Join Excite! - http://www.excite.com The most personalized portal on the Web! ----------------- http://www.imperialclub.com ----------------- This message was sent to you by the Imperial Mailing List. Please reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be shared with everyone. Private messages (and attachments) for the Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm