Harbor Freight Tools has several models
starting at $40
http://www.harborfreight.com/cpi/ctaf/Category.taf?CategoryID=516
Ken
’67 Crown 4 Dr Ht
From:
mailing-list-owner@xxxxxxxxxxxxxxxx
[mailto:mailing-list-owner@xxxxxxxxxxxxxxxx] On
Behalf Of Frederick Joslin
Sent: Monday, February 27, 2006
8:58 AM
To: mailing-list@xxxxxxxxxxxxxxxx
Subject: Re: IML: Engine/trans.
stands
I got a very good one
from Sam's Club in 1997. About $40 as I recall. It had no problems with a 413
and a 400.
----- Original Message -----
From: dansgarage@xxxxxxxxxxxx
To: mailing-list@xxxxxxxxxxxxxxxx
Subject: Re: IML: Engine/trans. stands
Date: Mon, 27 Feb 2006 0:13:01 -0500
Hi All...well, I picked up a 440 engine (and
Trans) from a 1966 Imperial over the weekend
and now the big question is.....does anyone
have suggestions as to what brand of engine
stand (this is for a 440 motor remember) would
be a good one for me to use? also, bearing in
mind that I am in southern California,
any
suggestions as to best place to GET the stand
from? I noticed Kragers Auto has then ( here in
town) but I would like to know if anyone's
experience has told than a particular stand was
'Good" or "Never again".
Feel free to contact me direct at "dansgarage@xxxxxxxxxxxx".
Thanks all!
Dan Melnik
----------------- http://www.imperialclub.com -----------------
This message was sent to you by the Imperial Mailing List. Please
reply to mailing-list@xxxxxxxxxxxxxxxx
and your response will be
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm
Fred Joslin