Re: IML: 73 Carb..
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: IML: 73 Carb..



been working on cars for 25 years, ever have had to use a thread sealer on a flare fitting.


From: Brad Hogg <LuxoLiner@xxxxxxx>
Jerry. There are two fittings there. Take the metal fuel line off the carb, screw the larger fitting into the carb firmly, using teflon tape is advised, then do the same with the fitting on the metal fuel line, also with teflon tape. You can use two wrenches to finish up and be sure everything is tight, without damaging the carburetor. If it still leaks, you may have a hair line crack in the carb from someone overtightening the fitting. In this case, I'd be looking for a replacement from the rebuilder..

Merry Christmas to you too! I got a 426 Hemi working model for Christmas! How happy am I!



----- Original Message ----- From: jhplc@xxxxxxxxxxx
> After much thought, I went for the rebuilt TQ instead of the
> Edelbrock transplant..(easier to do in 20 degree weather)...it
> works fine, except the fuel fitting on the carb leaks, even with
> teflon tape and the fitting tight..any ideas or did I miss
> something...thanks in advance
>
> Jerry
> 73
> Merry Chrysler
> Happy New Yorker...(76-78 for Imperial content!!)





----------------- http://www.imperialclub.com -----------------
This message was sent to you by the Imperial Mailing List. Please reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm




Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.