Re: IML: 727 Transmission not shifting into 3rd...
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: IML: 727 Transmission not shifting into 3rd...



Hi Javier,
A 727 Torque Flite that won't shift into drive most likely have a front clutch seal problem. You can eliminate the other causes by trying to shift it manually 1-2-3 from a dead stop. The front clutch seal would require removal of the transmission and you might as well go completely through it as long as it's out. We'd be happy to rebuild it for you at our shop.
Stevan Miner
Miner Auto Service
Winnebago, MN
----- Original Message -----
From: javier
Sent: Saturday, August 06, 2005 8:49 AM
Subject: IML: 727 Transmission not shifting into 3rd...

Good morning all!

 

I?m looking at a 68 Convertible in my area that wouldn?t shift into 3rd gear on my short test drive.  I looked into the repair section of the site to see a list of possibilities and maybe I mis-read the section? I found tons of references to letting the Torque Converter fill before driving off, but I didn?t see much about problems shifting into 3rd gear.  Does the torque converter cover this as well?

 

Since I?m not a mechanical sort, can someone enlighten me on the basics of transmissions, the leading causes of why a transmission would not shift into higher gears, and if I should run in the opposite direction from a car whose front brakes (Bud system) pulsate and transmission won?t hit high gear.  Otherwise this car is ?all there? but needs clean up and touch up.

 

Thanks,

 

javier



Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.