The Forward Look Network | ||
| ||
GE Headlights 1960 Dodge Jump to page : 1 Now viewing page 1 [50 messages per page] | View previous thread :: View next thread |
Forward Look Swap Meet -> Wanted - All Wanted Ads | Message format |
60Finatic |
| ||
Member Posts: 30 Location: New Jersey | Anyone have a pair of hi beam GE headlights with the round GE emblem in the center? I could use a pair of them asap. These are for my 1960 Dodge. If they are not 101% correct for a 60 Dodge I dont know but they need to match the low beams which are present and working. They have a circular GE emblem in the center of the headlight about 1/2 inch diameter. | ||
56D500boy |
| ||
Expert 5K+ Posts: 9908 Location: Lower Mainland BC | . Here is a NOS 1753 435 high beam bulb and I do NOT see any round GE logo on it. I see GE on the front and a GE "Mazda" stamp on the back. | ||
60Finatic |
| ||
Member Posts: 30 Location: New Jersey | What I am looking for has the two straight prongs on the back and a small circular GE emblem in the center of the bulb. | ||
Powerflite |
| ||
Expert 5K+ Posts: 9673 Location: So. Cal | I have one on my parts car, but not sure if it works or not. Even if it does, there's no guarantee how long it will continue to work. My gold New Yorker has both low beam GE lights, but the high beams are plain. Edited by Powerflite 2024-02-28 9:12 PM | ||
56D500boy |
| ||
Expert 5K+ Posts: 9908 Location: Lower Mainland BC | Powerflite - 2024-02-28 6:10 PM My gold New Yorker has both low beam GE lights, but the high beams are plain. The low beam lights are PN 1753 436 and are two filament, i.e. low stays on when you hit the high beam switch which brings on the second (high beam) filament as well as putting power to the separate single filament high beam 1753 435 light. The 1753 436 would have three connector tangs on the back Perhaps the low beams were the only one with this GE symbol in the middle. (???) The closest that I can find is this one: ??? Edited by 56D500boy 2024-02-29 3:12 PM | ||
Space Trukin Wagon |
| ||
Extreme Veteran Posts: 427 Location: Ohio | In response to this statement above: " Perhaps the low beams were the only one with this GE symbol in the middle. (???) " ALL factory installed / assembly line parts WOULD have logo. In addition they should be matched, meaning if headlamps are GE than all would be GE. [of course there are always exceptions where mixed or incorrect parts were installed by the factory. An example specifically on headlights is that its well documented that some Superbirds use both GE and Westinghouse, but lets not get distracted on that subject] I have numerous original GE headlamps both the Low & High beam and also Wide and Narrow flute style that ALL have the GE logo. Since the original post asked about 1960 Dodge, attached is a picture of the original GE headlamps installed in one of my 1960 Dodge station wagons. Note that both the Low and High beam have the GE center circle logo. Edited by Space Trukin Wagon 2024-03-06 4:11 PM (Original_Headlamps.jpg) Attachments ---------------- Original_Headlamps.jpg (208KB - 18 downloads) | ||
Jump to page : 1 Now viewing page 1 [50 messages per page] |
Search this forum Printer friendly version E-mail a link to this thread |
(Delete all cookies set by this site) | |