The Forward Look Network | ||
| ||
1961 Plymouth Savoy 2 Door Sedan Jump to page : 1 Now viewing page 1 [50 messages per page] | View previous thread :: View next thread |
Forward Look Swap Meet -> Parts Cars - VEHICLES BEING PARTED OUT | Message format |
jboymechanic |
| ||
Expert Posts: 2206 Location: Muskego, WI | I will begin parting this car ASAP. I will be keeping a few items for my 1960 Plymouth wagon, the rest is up for grabs. Slant 6, 3 speed on the column. Front disc brake conversion, car runs drives and stops. Very nice grill. Good hood, trunk lid and doors. Fenders have rust in bottom corners, but overall very nice. Solid trunk floor. Rear defrost. Chrome Fury tail lights. Pictures in the link below. http://www.forwardlook.net/forums/forums/thread-view.asp?tid=72949&... | ||
Apollo 61 |
| ||
Elite Veteran Posts: 775 | I would be interested in grille Plymouth emblem on rear section. If you happen to have dash rear defogger bezel? Ignition key with bezel,door locks glove box lock and trunk lock. I sure there's many more things I can use. | ||
Apollo 61 |
| ||
Elite Veteran Posts: 775 | I would be interested in chrome tailights also | ||
jboymechanic |
| ||
Expert Posts: 2206 Location: Muskego, WI | PM me with a dollar amount offer for each item and we'll go from there. | ||
jboymechanic |
| ||
Expert Posts: 2206 Location: Muskego, WI | walk around of the car: https://www.youtube.com/watch?v=a3Ilp0Caj98 | ||
Apollo 61 |
| ||
Elite Veteran Posts: 775 | Interesting idea on parting out cars with video. I will have to try that sometime | ||
jboymechanic |
| ||
Expert Posts: 2206 Location: Muskego, WI | This car was completely disassembled yesterday other than any suspension parts. For those of you that have already contacted me by PM or email, I will begin responding tonight with pictures. Everyone else, let me know what you need. | ||
Powerflite |
| ||
Expert 5K+ Posts: 9958 Location: So. Cal | Is that a 2bbl carburetor? | ||
jboymechanic |
| ||
Expert Posts: 2206 Location: Muskego, WI | Hear is a list of MOST parts with prices WITHOUT shipping: Grill, very nice, but screw through Plymouth emblem - $150 Rear quarter stainless, pair - $100 Steering wheel, 1958 Plymouth, no horn button - $50 Running slant six, minus starter, alternator and distributor - $150 3 speed manual trans, rolls smooth, no noises when driven - $75 Driver fender, very nice other than behind head lights and bottom behind wheel well - $75 Pass fender, very nice other than behind head lights and bottom behind wheel well - $75 Rear windshield - $100 Rear windshield stainless trim, vey straight - $100 Rear defrost setup (no original dash switch), works - $100 Driver door, very nice, with glass and regulator - $150 Pass door, very nice, with glass and regulator - $150 Gas tank with cap and sending unit, very nice - $150 Driver rear quarter glass and manual regulator - $50 Pass rear quarter glass and manual regulator - $50 Hood, outside skin is very straight, but rusted out on inside near pass hinge and front inside edge - $50 Trunk lid, outside skin is very straight, but rusted out on inside edge - $50 Driver front panel below fender behind bumper, solid and straight - $25 Passenger front panel below fender behind bumper, solid and straight - $25 Vertical front core support brace - $25 Horizontal piece that joins the top front fenders and hood latches to, slight bend but can be straightened - $25 Center grill brace - $15 Very nice chrome tail light housings - $35 each Rolling chassis and body shell with VIN and WI title in my name. No brakes, but will leave front steering linkage. - $150 All prices are or best offer, looking to move this stuff fast to clear out my garage. I haven't listed some stuff yet, if you don't see it just ask. If it doesn't sell it will most like get scrapped. Send me a PM with what you want and provide a cell number I can text pictures to or an email address so you can see condition. I will posting this on FB as soon as I can as well. Located in Milwaukee, WI area. (Plymouth Stripped 1.jpg) (Plymouth Stripped 2.jpg) (Plymouth Stripped 3.jpg) (Plymouth Stripped 4.jpg) Attachments ---------------- Plymouth Stripped 1.jpg (113KB - 347 downloads) Plymouth Stripped 2.jpg (105KB - 335 downloads) Plymouth Stripped 3.jpg (115KB - 335 downloads) Plymouth Stripped 4.jpg (91KB - 335 downloads) | ||
jboymechanic |
| ||
Expert Posts: 2206 Location: Muskego, WI | UPDATE, MANY OF THE ITEMS HAVE SALES PENDING Hear is a list of MOST parts with prices WITHOUT shipping: Grill, very nice, but screw through Plymouth emblem - $150 PENDING Rear quarter stainless, pair - $100 PENDING Steering wheel, 1958 Plymouth, no horn button - $50 PENDING Running slant six, minus starter, alternator and distributor - $150 3 speed manual trans, rolls smooth, no noises when driven - $75 Driver fender, very nice other than behind head lights and bottom behind wheel well - $75 PENDING Pass fender, very nice other than behind head lights and bottom behind wheel well - $75 PENDING Rear windshield - $100 Rear windshield stainless trim, vey straight - $100 Rear defrost setup (no original dash switch), works - $100 Driver door, very nice, with glass and regulator - $150 PENDING Pass door, very nice, with glass and regulator - $150 PENDING Gas tank with cap and sending unit, very nice - $150 Driver rear quarter glass and manual regulator - $50 PENDING Pass rear quarter glass and manual regulator - $50 PENDING Hood, outside skin is very straight, but rusted out on inside near pass hinge and front inside edge - $50 PENDING Trunk lid, outside skin is very straight, but rusted out on inside edge - $50 Driver front panel below fender behind bumper, solid and straight - $25 PENDING Passenger front panel below fender behind bumper, solid and straight - $25 PENDING Vertical front core support brace - $25 PENDING Horizontal piece that joins the top front fenders and hood latches to, slight bend but can be straightened - $25 PENDING Center grill brace - $15 PENDING Very nice chrome tail light housings - $35 each PENDING Rolling chassis and body shell with VIN and WI title in my name. No brakes, but will leave front steering linkage. - $150 All prices are or best offer, looking to move this stuff fast to clear out my garage. I haven't listed some stuff yet, if you don't see it just ask. If it doesn't sell it will most like get scrapped. Send me a PM with what you want and provide a cell number I can text pictures to or an email address so you can see condition. I will posting this on FB as soon as I can as well. Located in Milwaukee, WI area. | ||
jboymechanic |
| ||
Expert Posts: 2206 Location: Muskego, WI | UPDATE, removing items that have been paid for and adding items not previously listed: Grill, very nice, but screw through Plymouth emblem - $150 PENDING Rear quarter stainless, pair - $100 PENDING Running slant six, minus starter, alternator and distributor - $150 3 speed manual trans, rolls smooth, no noises when driven - $75 PENDING Driver fender, very nice other than behind head lights and bottom behind wheel well - $75 PENDING Pass fender, very nice other than behind head lights and bottom behind wheel well - $75 PENDING Rear windshield - $100 Rear windshield stainless trim, vey straight - $100 Driver door, very nice, with glass and regulator - $150 PENDING Pass door, very nice, with glass and regulator - $150 PENDING Gas tank with cap and sending unit, very nice - $150 Driver rear quarter glass and manual regulator - $50 PENDING Pass rear quarter glass and manual regulator - $50 PENDING Hood, outside skin is very straight, but rusted out on inside near pass hinge and front inside edge - $50 PENDING Trunk lid, outside skin is very straight, but rusted out on inside edge - $50 Driver front panel below fender behind bumper, solid and straight - $25 PENDING Passenger front panel below fender behind bumper, solid and straight - $25 PENDING Vertical front core support brace - $25 PENDING Horizontal piece that joins the top front fenders and hood latches to, slight bend but can be straightened - $25 PENDING Center grill brace - $15 PENDING Very nice chrome tail light housings - $35 each PENDING Front firewall and cowl with VIN and WI title in my name, transferable to you - $100 Front sub-frame with torsion bar suspension and steering linkage, no brakes (straight, but will need a few rust patches) - $100 Trunk hinges - $25 Trunk torsion bars - $25 Reverse light lenses - $10 Front bumper brackets - $20 | ||
jboymechanic |
| ||
Expert Posts: 2206 Location: Muskego, WI | UPDATE, removing items that have been paid for and adding items not previously listed: The front sub frame has been separated, the empty shell will be scrapped this Saturday, April 24th, so if you need something speak up now. Grill, very nice, but screw through Plymouth emblem - $150 PENDING Running slant six, minus starter, alternator and distributor - $150 3 speed manual trans, rolls smooth, no noises when driven - $75 PENDING Driver fender, very nice other than behind head lights and bottom behind wheel well - $75 PENDING Pass fender, very nice other than behind head lights and bottom behind wheel well - $75 PENDING Rear windshield - $100 Rear windshield stainless trim, vey straight - $100 Driver door, very nice, with glass and regulator - $150 PENDING Pass door, very nice, with glass and regulator - $150 PENDING Gas tank with cap and sending unit, very nice - $150 Driver rear quarter glass and manual regulator - $50 PENDING Pass rear quarter glass and manual regulator - $50 PENDING Hood, outside skin is very straight, but rusted out on inside near pass hinge and front inside edge - $50 PENDING Trunk lid, outside skin is very straight, but rusted out on inside edge - $50 Driver front panel below fender behind bumper, solid and straight - $25 PENDING Passenger front panel below fender behind bumper, solid and straight - $25 PENDING Vertical front core support brace - $25 PENDING Horizontal piece that joins the top front fenders and hood latches to, slight bend but can be straightened - $25 PENDING Center grill brace - $15 PENDING Very nice chrome tail light housings - $35 each PENDING Front firewall and cowl with VIN and WI title in my name, transferable to you - $100 Front sub-frame with torsion bar suspension and steering linkage, no brakes (straight, but will need a few rust patches) - $100 Trunk hinges - $25 Trunk torsion bars - $25 Reverse light lenses - $10 Front bumper brackets - $20 (sub frame 1.jpg) (sub frame 2.jpg) Attachments ---------------- sub frame 1.jpg (101KB - 331 downloads) sub frame 2.jpg (136KB - 339 downloads) | ||
jboymechanic |
| ||
Expert Posts: 2206 Location: Muskego, WI | UPDATE, removing items that have been paid for and adding items not previously listed: Running slant six, minus starter, alternator and distributor - $150 Rear windshield - $100 Rear windshield stainless trim, vey straight - $100 Gas tank with cap and sending unit, very nice - $150 Hood, outside skin is very straight, but rusted out on inside near pass hinge and front inside edge - $50 Front sub-frame with torsion bar suspension and steering linkage, no brakes (straight, but will need a few rust patches) - $100 Trunk hinges - $25 Trunk torsion bars - $25 Rear seat bench and back rest - $50 | ||
jboymechanic |
| ||
Expert Posts: 2206 Location: Muskego, WI | UPDATE, removing items that have been paid for and adding items not previously listed: Not much left and I have all my money out of this car and the parts I wanted for my wagon. I'm counting this a win for me at this point, anything not sold will be scrapped soon so step up with an offer. Running slant six, minus starter, alternator and distributor - $150 OR Running slant six with starter, alternator and distributor - $300 (distributor has Pertronix conversion, alternator and starter are new) Rear windshield - $100 Gas tank with cap and sending unit, very nice - $150 Hood, outside skin is very straight, but rusted out on inside near pass hinge and front inside edge - $50 Trunk Hinges with torsion bars - $30 Front sub frame, complete minus brakes - $100 If the sub frame get parted: Torsion bars - $50 each Spindle - $30 each Suspension Arm, upper - $25 each Suspension Arm, lower - $25 each Strut rod - $15 each Steering arm - $20 each Idler arm - $20 Center link - $50 Tie Rods - $20 each Thank you to those of you who have purchased parts. | ||
jboymechanic |
| ||
Expert Posts: 2206 Location: Muskego, WI | UPDATE: Down to just the front sub frame and parts: Front sub frame, bare - $75 Torsion bars - $50 each Spindle - $30 each Suspension Arm, upper - $25 each Suspension Arm, lower - $25 each Strut rod - $15 each Steering arm - $20 each Idler arm - $20 Center link - $50 Tie Rods - $20 each | ||
pistolgrip |
| ||
Veteran Posts: 118 Location: Maryland | Jon, I know this is an older post, but was wondering if you have anything left of this thing? I wouldnt mind having the push-button/auto trans delete/block off, and possibly all 4 of the control arms. Thanks.... P.S. I'll try sending you a PM as well.... | ||
Jump to page : 1 Now viewing page 1 [50 messages per page] |
Search this forum Printer friendly version E-mail a link to this thread |
(Delete all cookies set by this site) | |