|
|
Regular
Posts: 57
Location: Switzerland | Today my Mirror Matic Mirror package from Sweden arrived with a 1959 stile Mirror Matic Mirror. Unfortunately the electron tube with 7 pins was broken, maybe during transport.
The only word and number I can read is TUNG-... and a number 3225906-..
Can somebody identify the part, if this still exists, i would like to replace it or if somebody has a work around with modern parts I would be very happy
Thank you all
Dani |
|
|
|
Board Moderator & Exner Expert 10K+
Posts: 13049
Location: Southern Sweden - Sturkö island | RCA 12K5 for instance or GE 12K5
https://www.ebay.com/itm/12K5-GE-tube-vintage-working-Radio-tube-as-...
|
|
|
|
Regular
Posts: 57
Location: Switzerland |
Whow that was Quick !
Thanks a lot.
Anybody knows about the Resistor rating of Highway or City position.
I asume the poti's are beond their live cycle ,, couldn't get a valuable reading when tested...
Dani |
|
|
|
Board Moderator & Exner Expert 10K+
Posts: 13049
Location: Southern Sweden - Sturkö island | Just wait until you get the replacement tube Daniel. They normally work even after all those years. Mind that there's a "warm-up" time before the mirror works.
Connect the mirror to the "H" terminal on the light switch with an additional toggle switch (I beleive you have the "dipped beam law" during daytime as well as we), otherwise the mirror will be "hot" all the time which is bad for the mirror. |
|
|
|
Regular
Posts: 57
Location: Switzerland | wizard - 2019-12-17 3:47 PM
Just wait until you get the replacement tube Daniel. They normally work even after all those years. Mind that there's a "warm-up" time before the mirror works.
Connect the mirror to the "H" terminal on the light switch with an additional toggle switch (I beleive you have the "dipped beam law" during daytime as well as we), otherwise the mirror will be "hot" all the time which is bad for the mirror.
Tank you Wizard,
Yes we have now the same law in Switzerland. i will sure consider to put a swich between it.
shall I also put a fuse to it , thought about 5 or 10 amps ?
Dani |
|
|
|
Board Moderator & Exner Expert 10K+
Posts: 13049
Location: Southern Sweden - Sturkö island | Try with a 5 Amp fuse first Daniel
(Mopar Mirror-matic.jpg)
Attachments ---------------- Mopar Mirror-matic.jpg (139KB - 260 downloads)
|
|
|
|
Expert
Posts: 1530
Location: ZH, Switzerland | In mine, also a 1959 MirrorMatic is the coil broken (the fine wire respectively). I do not get an Ohm value between the two posts of the coil.... |
|
|