|
|
Extreme Veteran
Posts: 441
Location: Ohio | Looking for nice original door sill plates for 1960 Dodge 2-dr hardtop
Believe that the 1961 model uses the same style / design door sills
Or are there any sources for reproduction 1960-61 Dodge door sills ?
The only reproductions I've seen are for the 1957-1959 models |
|
|
|
Extreme Veteran
Posts: 441
Location: Ohio | Since there have been a lot of views but no replies on repro 1960-61 door sills.
Does anyone have recommendation for a plating / trim shop that can restore original aluminum door sill plates ?
(including reanodizing) |
|
|
|
Expert
Posts: 2519
Location: central Illinois | I've sent in my 60 DeSoto plates, which should be similar, to be reanodized a couple weeks ago to Special T's in Prospect Hts, IL. He has a turn around time of 2-3 months. When I get them back I can post some pictures and let you know how they turn out and what they cost. He only advertises in Mopar Collector's Guide and has a great business going, specializing in 65 Hemi B body grills. Mine had some bad creasing from being forced down on the carpet which was doubled over from the factory and lots of pitting. Pitting is the biggest issue because he can sand and polish out only so much. He did my grill insert and cowl panel which turned out very nice but still show some pitting which was very deep. |
|
|
|
Expert
Posts: 2905
Location: little rock, AR | Are you looking for the SR model sill plates or the Jr. Model for the 1960 Dodge??? |
|
|
|
Extreme Veteran
Posts: 441
Location: Ohio | Still trying to find Door Sill Plates for 1960-61 Dodge 2-door
Will buy pairs or singles
Also have parts to trade
The door sills measure 42" and should have the pattern stamped as shown in the photo
Edited by Space Trukin Wagon 2017-11-11 1:22 PM
(IMG_1898.JPG)
Attachments ---------------- IMG_1898.JPG (75KB - 49 downloads)
|
|
|