|
|
Veteran
Posts: 101
Location: Upper Darby, PA | Every part store I've tried - including NAPA - lists a 5/8" ID washer for the A block. Mine is 7/8" - I can buy twenty of 'em on Amazon, but it will be next week before I get them.
Has anyone else run into this? I don't care if it's for a Mazda - can someone tell me what year/make/model requires a 7/16" crush gasket? None of the counter jockeys I've encountered are inclined to rummage, but if I can point them to chapter and verse, perhaps I can resolve my dilemma in short order.
adTHANKSvance
Dan |
|
|
|
Expert
Posts: 3431
Location: Chestertown, NY ( near Lake George) | Try and convert that to a metric size, that's how modern oil pan drain plug washers are sized. 11mm might work. Here's a sample. https://www.amazon.com/F4XY-6734-11026-01M02-Sealing-Compatible-Infi...
Edited by Shep 2024-06-11 6:29 PM
|
|
|
|
Veteran
Posts: 101
Location: Upper Darby, PA | D’Oh! Of course - great idea. Thanks! (I think 22mm is what I’ll need.) |
|
|
|
Expert
Posts: 3431
Location: Chestertown, NY ( near Lake George) | 7/16 is about 11mm. 22mm is almost 7/8. |
|
|
|
Veteran
Posts: 101
Location: Upper Darby, PA | My bad, Shep - I meant 7/8". I've since corrected my post. Thanks for the suggestion, I've ordered from Amazon, will be here Thursday! I'm all set. |
|
|