Good morning hondanan1974,, The Wizard is correct, just make your own pipe. I used 1/4" tubing that I had from scrap leftover from another project. Exhaust mainfold end; I took a 3/8" copper tube & brazed a threaded 1/4" compression end to it, then pressed this into to pipe going into the exhaust manifold. On the 1/4" I attached a 1/4" compression fitting. Used a tubing bending tool for the 1/4 inch tube & followed the same shape of the old rusted tube. I have the WCFB 4 bbl carb on my 270 hemi which has a slightly different tubing layout that the 2bbl Stromberg. Used a brake flaring tool for the fitting that attaches to the choke housing end Looked everywhere for the woven cover but could not anything that came close to the look of the factory asbestos woven cover. I came across Classic Tube in New York and spoke with Tim Slattery (Senior Sales Rep) 800.882.3711 <tslattery@classictube.com> who said he could possibly fix me up.
Told him what size tube (1/4") and what length (29"). in less than a week this is what was provided.
Edited by '55-3Hemi 2021-04-04 9:13 AM
(Exhaust manifold tubing b.JPG)
(Exhaust manifold tubing A.JPG)
(IMG_9815.JPG)
(IMG_2217.JPG)
Attachments ---------------- Exhaust manifold tubing b.JPG (28KB - 193 downloads) Exhaust manifold tubing A.JPG (26KB - 189 downloads) IMG_9815.JPG (27KB - 183 downloads) IMG_2217.JPG (71KB - 189 downloads)
|