|
|
Board Moderator & Exner Expert 10K+
Posts: 13054
Location: Southern Sweden - Sturkö island | For to remove the pulley from the power steering pump without any damages a special puller is needed.
This is my homemade puller consisting of 5 different parts.
It took me some time to make it, turning the parts in the lathe, welding the parts together with TIG, but the removal of the pulley went extremely smooth.
I'll post some pictures of the other tools I made for the pump as I start to renovate the pump.
(Pulley_Puller_1.jpg)
(Pulley_Puller_2.jpg)
(Pulley_Puller_3.jpg)
(Pulley_Puller_4.jpg)
(Pulley_Puller_5.jpg)
Attachments ---------------- Pulley_Puller_1.jpg (188KB - 197 downloads) Pulley_Puller_2.jpg (233KB - 205 downloads) Pulley_Puller_3.jpg (229KB - 213 downloads) Pulley_Puller_4.jpg (221KB - 222 downloads) Pulley_Puller_5.jpg (222KB - 218 downloads)
|
|
|
|
Board Moderator & Exner Expert 10K+
Posts: 13054
Location: Southern Sweden - Sturkö island | The pulley has spent some time in my Strip-All bath
Strip-All is a product from Drake Chemicals in Norway, removes all, paint and rust.
Sorry, this page is in Swedish http://www.strip-all.com/se/ |
|
|
|
Expert 5K+
Posts: 8444
Location: Perth Australia | Nice work as always Sven
Might have to make one as well
|
|
|
|
Board Moderator & Exner Expert 10K+
Posts: 13054
Location: Southern Sweden - Sturkö island | Next set of tools;
(Shaft_Needlebearing_Puller-1.jpg)
(Shaft_Needlebearing_Puller-2.jpg)
(Shaft_Needlebearing_Puller-3.jpg)
(Shaft_Needlebearing_Puller-4.jpg)
(Support-1.jpg)
(Support-2.jpg)
(Ferrule_Socket-1.jpg)
(Ferrule_Socket-2.jpg)
Attachments ---------------- Shaft_Needlebearing_Puller-1.jpg (206KB - 217 downloads) Shaft_Needlebearing_Puller-2.jpg (267KB - 206 downloads) Shaft_Needlebearing_Puller-3.jpg (252KB - 200 downloads) Shaft_Needlebearing_Puller-4.jpg (290KB - 209 downloads) Support-1.jpg (246KB - 205 downloads) Support-2.jpg (128KB - 201 downloads) Ferrule_Socket-1.jpg (188KB - 207 downloads) Ferrule_Socket-2.jpg (200KB - 208 downloads)
|
|
|