finsruskw - 2017-08-21 9:51 AM
Install the converter 1st, than finish the install
(bellhousing
) then transmission, using pin guides as stated in the FSM
You can make them from long bolts by removing the head, tapering the shank end and cutting a slot
in that end so you can put 'em in and take 'em out w/a screwdriver.
Do you have a jack to support and align the trans while installing??
Or are you trying to he-man/manhandle it in? if so, all bets are off
Get/download/print or whatever the manual and read the install section
It is available here for free.
It will be a Chrysler manual but the install step by step should be the same
http://jholst.net/300resource/index.php
Good luck and BE CAREFULL!!
You only want to do this once and not have to be pulled from under the car by EMT's