You are right, go to about 12:35 minutes in and he discusses starting the 4 headlight system, but I agree does not really
go into it as well as he does the two bulb. But the general setup / explanation / process he uses for the 2 bulb applies to
the 4 bulb too. The Mopar factory service manual goes into the process of course, but it assumes you have a funky
dealer headlight aiming contraption. If you get the low beam adjusted to your satisfaction then you can concentrate on
the high beam.
Look at # 5 and # 6 in the "Aiming Procedure" section on this web page and see if that helps:
https://www.hotrodhotline.com/headlights-part-2-lowhigh- beams#.XTt0W5OYXIU
Thanks,
Gary H.
> -------Original Message-------
>
> Thanks Gary,
>
> Thanks for the link and response. Without a doubt I am over-thinking
> a problem however while working on the lights I would like to try to
> get closer than I am now.
>
> I have seen this video and now watched it again. It is one of the
> best for single headlights. However when he got to the 4 headlight
> system the only thing he said was that the car had too many issues to
> do at this time.
>
> I was not able to tell or I missed it if he was adjusting with the
> lights on low or high beam?
>
> I think I will adjust the low beam lights like he did the Mustang
> lights. In the 1963 Service Manual it shows how to adjust a Valiant
> with single head lights. I will use this chart to set the high beams.
>
> Any thoughts on where I am headed with the adjustments?
>
> Again, thanks for the info and quick response.
>
> Dennis C.
>
> On Friday, July 26, 2019 at 6:33:31 AM UTC-7,
> 62-65-mail...@xxxxxxxxxxx wrote:
>
> > It would help to include the link to the video. LOL Here it is:
> >
> > https://youtube.com/watch?v=0euMSWwgQSY
> >
> >> -------Original Message-------
> >> From: 62-65-mail...@xxxxxxxxxxx
> >>
> >>
> >> This video uses a F*rd as a reference (oops!) but about 12
> > minutes in discusses a 4 headlight system.
> >>
> >> Thanks,
> >> Gary H.
> >>
> >>> -------Original Message-------
> >>
> >>> Hello,
> >>>
> >>> I'm working on my 63 Sport Fury and would like to adjust the
> >>> headlights. I am finding good instruction on single high/low
> > beam
> >>> headlights but nothing on adjusting a 4 headlight system. Any
> >
> >>> suggestions would be appreciated. I know I can get close by
> > using the
> >>> 25 foot system and taking measurements but not sure where the
> > best way
> >>> with the 4 lamps.
> >>>
> >>> Thanks
> >>> Dennis C.
>
> --
> --
> --
> Please address private email -- email of interest to only one person
> -- directly to that person. That is, email your parts/car transactions
> and negotiations, as well as other personal messages, only to the
> intended recipient. Do not just press "reply" and send your email to
> everyone using the general '62-'65 Clubhouse public email address.
> This practice will protect your privacy, reduce the total volume of
> mail and fine-tune the content signal to Mopar topic. Thanks!
>
> 1962 to 1965 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html and
> http://www.1962to1965mopar.ornocar.com/general_ .disclaimer.html
> --
> You received this message because you are subscribed to the Google
> Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
> http://groups.google.com/group/1962to1965mopars?hl=en .
> ---
> You received this message because you are subscribed to the Google
> Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
> To unsubscribe from this group and stop receiving emails from it,
> send an email to 1962to19...@googlegroups.com .
> To view this discussion on the web visit
> https://groups.google.com/d/msgid/1962to1965mopars/ .bf58fcf5-16e0-4d45-8f75-
4a37aec55e60%40googlegroups.com
>