No, well clear of that. It is hitting the shock tower, however. (Maybe I need to Hemify the shock tower? God, I hope not. $$$$)
Akron Don Gallimore
On Sunday, May 26, 2019, 1:16:55 PM EDT, chuckiiikropke <chuckiiikropke@xxxxxxxxx> wrote:
Where the shock bolts through its hitting?
Sent via the Samsung Galaxy S7 active, an AT&T 4G LTE smartphone
-------- Original message --------
From: Donald Gallimore <dongallimore@xxxxxxx>
Date: 5/26/19 11:11 AM (GMT-06:00)
To: The 1962 To 1965 Mopar Mail List Clubhouse <1962to1965mopars@xxxxxxxxxxxxxxxx>
Subject: Doug's Headers Too Close to Fender
Put a set of 2" Doug's Heads (D452) on my 440 powered '65 Belvedere yesterday. Incredibly easy install.
HOWEVER, after I was all done, I went to pull the light blanket I was using to protect the paint and the tube from #2 cylinder which runs above the rest of the tubes to the back was essentially resting on the passenger inner fenderwell. I did noticed the motor mount on that side was twisted to the driver's side. The CL of the crank was 5" above the K frame and the offset to the passenger side was 3", both of which nearly meets TTI's suggested distance but are a little tight but by only 1/4".
Anybody experience this or have any suggestions to correct this situation? Not looking to going to an engine plate.
Akron Don Gallimore
--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
Back to the Home of the Forward Look Network