Re: Disc Brake conversion question.

["Frank W. Schultheis" <fwschultheis35@xxxxxxxxx>]

If the M'Cyl bore diameter is the same or bigger than your original, the pressure ratio can cause poor stopping power.

On Fri, Jan 11, 2019 at 7:29 AM <62-65-mail-list-club@xxxxxxxxxxx> wrote:

Contact the vendor for their thoughts. And verify they sent you the correct parts too.

Thanks,
Gary H.

>  -------Original Message-------
>  From: howard cox
> 
>  I have a question. I have a 65 B body that i installed front disk brakes from The Right Stuff with their master
cylinder(non power). The lines are bleed and the pedal if firm but I don't seem to have the stopping power that I think I
should. Any suggestions? Thanks.

--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.

-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.