Re: Trunk Lid underside Insulation Question

[carverex@xxxxxxx]

Hi Mark

Did you have the visor on top of the IP re-done? If so, who did it. It looks to good to be original??

Thanks

Lyle

On Tuesday, February 13, 2018 at 11:56:44 AM UTC-5, hmse...@xxxxxxx wrote:

I have my 62 Plymouth Conv Trunk lid apart to fix some rust areas.
There is no black waffle fiber insulation material between the inner and outer Trunk metal panels.

Should there be any of the black insulation between the panels in the cutout spaces on a 1962 Plymouth?

Also the reason these trunks always rust form the inside out is ,there is no primer/paint of any kind where the panels meet together just bare metal
Mark

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.