Re: Stroker lit up, but I have issues
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Stroker lit up, but I have issues



Fellas, I think I may have found the smoking gun.

This morning I took some good advice from Stan and replaced the intake bolts.  Went to a 3/8-16 x 1 3/4 inch long set of bolts, which gave me about 3/8" more reach than the ARPs I had on there.  In the process of replacing the bolts, I found the one over #2 cylinder to be stripped.

After speaking with Bruce Roland, conventional wisdom is that it was probably a not getting a good seal from the short bolts and / or the stripped one.  Regardless, the way forward is to yank that intake and heli coil the head, then start over.  I'll keep everyone posted.

Can't say enough about the help from everyone.  I sincerely appreciate it.

Thank you,

Jim



On Sunday, September 14, 2014 5:33:07 PM UTC-4, JimJablonski wrote:
Well. I finally got the stroker to light up, but I've got some issues.  I hope it's not serious, but it doesn't sound good.  I had to advance the timing to about 50 degrees to get it to start, and after break-in, I can't get it to idle below about 1,800 RPM.  And there is an obvious miss when you kick the throttle.  My 1st thought on the idle was a vacuum leak, but I ran some propane around the intake and nothing happened.  The timing and the miss have me concerned.  Could I have possibly screwed up the timing chain marks?  Any thoughts?

The good news is I have awesome oil pressue and no leaks.  It sounds freaking wicked.  Here's a video:



Thanks,

Jim

--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.


Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.