Perfect. Thanks
I think it is this: http://www.con2r.com/offset-s1/
But I assume Grant should be able to confirm this is the measurement they want to know.
Thanks,
Gary H.
> -------Original Message-------
> Hi guys - I need a bit of info. I would like to replace the steering wheel
> on my 65 Barracuda with a Grant walnut wheel. One of the measurements
> required is the "dish offset". I am not sure if this is measured from
> the steering wheel rim to the center of the horn ring or to the frame of
> the wheel itself under the horn ring. Any ideas? Bob from Maine.
--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.
Back to the Home of the Forward Look Network