440 Pistons and Rod Recomendations

[Donald Gallimore <dongallimore@xxxxxxx>]

Need new pistons and rods for my 440. 

This will be a 6000 rpm motor, 500 HP at flywheel. 40 over. Have 452 open chamber heads and would like quench piston with a pump gas 93 octane friendly motor. Right now looking at 440 Source as one supplier. Also considering JE SRP piston and Eagle rods. Chevy .990 piston pin diameter is okay.

I'm facing a big bill and not sure the wife is gonna take it well. Will spend the money but this ain't no Top Fuel engine so want to be reasonable. Car will be a race car for the next few years but will be back on the street with this motor eventually.

 

Akron Don Gallimore

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.