Re: New driveshaft install

On Fri, Oct 18, 2013 at 6:28 PM, <furyus63@xxxxxxxxxxx> wrote:

Well today was the big day to install my new driveshaft and fix a small leak in my tranny. Once the car was up in the air the job was to be nothing more than replace the leaking gasket for the park cable cover and in with the new driveshaft. That's when it was discovered that the tailshaft housing was cracked. You ever get that feeling it's not going to be a good day.

For me I'm lucky I have the original trans which provided the doner unit and that the rear seal was in good condition. My pit crew did a great job as always replacing the tailshaft and with the new driveshaft installed we'll try some of those higher rpm shifts.

Nick Tiberio

FuryUs63

--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/groups/opt_out.