Can anyone tell me what the diameter of a 67+ Convertor hub is? And did they change from pre 66? The guy I'm talking to about my possible trans rebuild has been a Torqueflite specialist for decades and is convinced I'm going to have an clearance issue between my 65b cfrank and a 76+ convertor. I know I have a convertor in the garage but I'd have to tear the parts under my bench all to hell to dig one out. Thanks! Bill M 65 Coronet 500 'vert http://goo.gl/6xUS1 73 Dart Sport, 05 Ram 2500 CTD, 4WD, QC, LB, Laramie 21 Model T Depot Hack, 06 Mazda 3 -- -- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en. --- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx For more options, visit https://groups.google.com/groups/opt_out.