Re: Trim questions

Hello---The guy selling Alumiweld does a crack up job of welding aluminum beer cans together, I even did two myself. However be forewarned that it will not work at all on any aluminum trim that has the anodized coating on it and your original trim does have it. You would have to strip the anodizing off of the trim in order to weld it and then get it re-anodized after you weld it and get the welds ground down, filed, sanded and buffed out. Sounds like a lot more work than it is worth. I would start looking for a replacement molding ASAP. Also I happen to know this sad story from experience and ruined a rare piece of trim by thinking that I did not have it hot enough to make the Alumiweld stick. When I called the vendor about it, that was when he finally admitted that it will not work on anodized trim without stripping it first. Hope this email saves you a lot of un-needed greif. Good Luck, Charlie.

On Sat, May 4, 2013 at 12:05 PM, Tim Arnold <timna74@xxxxxxxxx> wrote:

Thanks for input!

Putting a piece behind sounds like a good idea!

Don, my car is the 440 model, 65 coronet 2dr ht. The damaged piece is the left rear quarter panel lower piece.

Thanks
Tim

--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/groups/opt_out.