Re: gasket diff to housing 8 3/4 "
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: gasket diff to housing 8 3/4 "



I have to agree, but my calculator does not have capacity to carry the digits out far enough  to show the alignment difference when moving one end of a (30in) axle .018 inches, I have my doubts that the final outcome would be any different than painting  your wheels and getting an extra layer of paint on half the wheel
 
In a message dated 12/31/2012 8:46:22 A.M. Central Standard Time, 493mike@xxxxxxxxx writes:
I agree with Steve. The gasket, after compression, is .018" thick and although a small amount it will affect axle shaft alignment.

--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
 
 
 


Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.