Re: Radiator requirement

["Paul L. http://1962to1965mopar.ornocar.org/ml-lennemann63.html" <pjlenn@xxxxxxxxx>]

I have tried several things.  The one that worked best (but still leaks a little) is Permatex Ultra Copper.  I have tried bolts and studs in this particular spot but the threads are bad enough that you can't get it tight.  Which I'm sure is the majority of the problem.  I will look into the Mopar sealer, Thanks

Paul L.

On Thursday, November 29, 2012 9:54:36 PM UTC-6, 62to65mopar wrote:

Is this the Mopar sealer referred to?
http://cdn.modernperformance.com/images/uploads/MoperOEMgasketsealant.jpg

Thanks,
Gary H

>  -------Original Message-------
...
>  Paul, what sealer are you using on that exhaust manifold stud?  Mopar
>  sells a sealer that has Mopar  label on it and is black in color. It
>  dries to a rubber like consistancy rather than silicone.  I really
>  like it and will probably never use silicone
>  again............................MO
>  
>  
>  

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.