Do you suppose it could be the float level set too low???? Maybe shutting off the gas when it's splashing around in the bowl??--Rich Kinsley '64 Dodge Polara LeRoar 4dr 324 poly w/goodies
On Sun, Nov 18, 2012 at 4:55 PM, Eric R <hoodoov...@xxxxxxxxx> wrote:This again.It still does it. Not vacuum booster. It's blocked off. I rebuilt carb and float levels looked good. Runs great.Carb had rust from tank. I cleaned it all out and installed fuel filter.So, it could be the pump?Could tank rust effect a pump so that pressure drop causes it to stall when I hot the brakes,It's the Carter 2bbl BBD.Tommorow I'll take off the pump and have a look.Thank you.
On Wednesday, August 8, 2012 1:50:29 PM UTC-4, Eric R wrote:--I got the 300 brakes situation worked out pretty well.With new plugs, cap/etc, and wires the engine sounds pretty good.On a short test drive when I hit the brakes the engine will stall. If I come to a real easy rolling stop then it's fine.I turned the engine idle up higher then normal out of curiosity and it still stalls.What could this be? Timing? Carb needs rebuilt?Thanks
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_ .disclaimer.html
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en .
--
Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies