Re: Car stalls when I hit the brakes

[Eric R <hoodoovoodooray@xxxxxxxxx>]

This  again.

 

It still does it.   Not vacuum booster.  It's  blocked off.  I rebuilt carb and float levels looked good.  Runs  great.

 

Carb had rust from tank.  I cleaned it all out and installed  fuel filter.

 

So,  it could  be the pump?

 

Could tank rust  effect a pump  so that pressure drop  causes it to stall when I hot the brakes,

 

It's  the  Carter  2bbl   BBD.

 

Tommorow  I'll take off the pump and have a look.

 

Thank you.

 

 

 

On Wednesday, August 8, 2012 1:50:29 PM UTC-4, Eric R wrote:

I got the 300 brakes situation worked out pretty well.

 

With new plugs, cap/etc, and wires the engine sounds pretty good.

 

On a short test drive when I hit the brakes the engine will stall.  If I come to a real easy rolling stop then it's fine.

 

I turned the engine idle up higher then normal out of curiosity and it still stalls.

 

What could this be?  Timing?  Carb needs rebuilt?

 

Thanks

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.