Not me. But go to the 62-65 Tech page http://1962to1965mopar.ornocar.com/techstuff.html and click on the "Welding Tips" link. There is also a forum for tig welders at that link too, if I recall correctly. Gary H. > -------Original Message------- > > anyone with tig knowledge/experience please sound off. I want to build > a tube frame and other stuff. I want to weld aluminum and chrome moly, > and also try it on sheet-metal. I know there is 110 units but I don't > know what they can do. I understand some tigs wont weld aluminum??? > And then whats this about turning an arc welder into a tig welder, how > do u do that? > Neal Zimmerman, Eugene Oregon -- -- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en.