Re: tapered rear axle versus straight axle-1964 Dodge 440 4-door

[Bill Watson <chrycoman@xxxxxxxxx>]

That it does.

If you want to remove the hub on that side you will need to use a hub
puller, just like the other side.  However, if you want to remove the
drum, no problem.  As you have found out it just slides off the studs.
 You will need to remove the hub only when you need access to the axle
seals or bearings.  Much less hassle.

Bill
Toronto, ON



On Thu, May 10, 2012 at 7:04 PM, beckstein@xxxxxxxxxxx
<beckstein@xxxxxxxxxxx> wrote:
> Hi Bill
>
> THanks for the reply. I just was working on it and there is indeed a
> nut on the end of the axle.
> Does this mean it is a tapered axle?
>
> John
>
> On May 10, 7:01 pm, Bill Watson <chryco...@xxxxxxxxx> wrote:
>> Is there a nut on the end of the axle?  If so, the drum was not
>> swedged onto the hub and instead had the stud holes widened to permit
>> the removal of the drum without using a hub puller.  Not uncommon.
>> The studs were attached to the hub and thus once the wheel was
>> installed over the drum, the lug nuts held the drum and wheel in
>> place.
>>
>> Tapered axle and straight axle are the same thing.  Starting in 1965
>> Chrysler used flanged axles that had a flange at the end into which
>> the studs were installed.  The drum then slid onto the studs.  Unlike
>> the hubs on pre-1965 models, the flange was not removable.
>>
>> Bill
>> Toronto, ON
>>
>> On Thu, May 10, 2012 at 5:21 PM, beckst...@xxxxxxxxxxx
>>
>>
>>
>> <beckst...@xxxxxxxxxxx> wrote:
>>
>> > I'm in the process of doing the brakes on my 64 Dodge 440-4door and
>> > found out drivers side rear axle is different then passenger side rear
>> > axle.
>> > The passenger side has the swedged drum hub on the tapered axle, but
>> > the drivers side has a newer drum separate from the wheel hub.
>>
>> > Since this is my first B-body what is the availability of replacement
>> > axles & hubs?
>>
>> > Has anyone ever seen this before?
>>
>> > This car will be a driver so I'm not concerned with keeping original
>> > equipment.
>>
>> > Any input or recommendations are appreciated.
>>
>> > John
>
>

-- 
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.