Re: pressed in axle removal

["Paul L. http://1962to1965mopar.ornocar.org/ml-lennemann63.html" <pjlenn@xxxxxxxxx>]

Take a box end wrench large enough to go over the axle.  Remove the
castle nut, slide the wrench over the axle and reinstall the nut.
Then give it good rap or two with a fist maul.  Should pop right out.

Paul L.

On Apr 16, 3:17 pm, Steve Chervinsky <63hemipol...@xxxxxxxxx> wrote:
> OK, I have the tool to remove the rear wheel flange on the 8 3/4, how
> does one remove the axles from the housing, I want to take the pig
> out.
>
> Slide hammer? Or does one get a piece of steel with a hole large
> enough to put the nut over the end of the axle and then have at it
> with a BFH?
>
> Any and all help is MUCH appreciated!!!
>
> --
> Steve
> '63 Hemi Polara

-- 
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.